Alternatively if you need the connector to fall in the 90-270 degree angles, the connectors can be modified to do so. For an extra charge we can cut a new notch at the angle you would like. We can cut these notches anywhere in the 90-270 degree range except for around 200 degree because that is where the tabs are that hold the connector together. Because of the factory notches we cannot cut extra notches between 270-90 degree. Please let us know the angle you would like and we can let you know the cost of this modification. Please keep in mind that we are not a metal shop and these are small and hard to cut cleanly there could be small scratches or nicks from this work.
You should be aware that when modified it can affect the latching of the connector. Figure 5 shows two options at 180deg. The male connector (5A) will cover the release latch making it hard to unplug. The female (5B) has its latch pressed by the body of the connector so will either not latch at all or may latch a little and the latch may be very hard to press in to release.
I hope this info page helps. If you have any questions please contact us.